Solar Seal is a custom fabricator of architectural glass products. We can cut, edge, drill, fabricate (add notches, cutouts etc.), sandblast, temper, add spandrel to, and insulate glass products.

  •   1-800-225-0430 (MA)
  •   55 Bristol Drive, South Easton, MA


  •   1-888-657-8852 (VA)
  •   35 Venture Drive, Stafford, VA 





It is very important that glass is handled properly after its receipt from Solar Seal or any other manufacturer. Solar Seal makes every attempt to get your product to you quickly and in undamaged condition. Solar Seal will not be held responsible for damage occurring after glass has been received at the jobsite or in a shop. Solar Seal has issued and recommends adhering to the following guidelines:

  • Glass received in crates should be unpacked immediately. Glass stored in unventilated crates for extended periods can incur surface damage. Glass should be stored indoors, protected from exposure to rain, standing water, direct sunlight and other adverse weather conditions.
  • Individual lites should be stacked on edge using clean cushioned padded blocks placed along the bottom edges of the glass. Cork or rubber separators should also be used between lites of glass to limit scuffing and scratching. Glass should be stacked against a sturdy support, resting at an angle of approximately seven degrees.
  • A dry, interleaving material should be used and edges should be protected from impact. Glass should never be rotated on the corners. A properly designed roll block should be used to avoid corner and edge damage.

For more information we urge you to review the Glass Association of North America’s (GANA) construction Site Protection of Architectural Glass.